Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 483

ip dos-protection-group
ipv6 dos-protection-group
lag dos-protection-group
ppp dos-protection-group
Copyright © 2010, Juniper Networks, Inc.
Use the no version to remove the attachment of the DoS protection group from the
interface.
See hdlc dos-protection-group.
Use to attach an IP DoS protection group to an interface.
Example 1
host1(config-if)#ip dos-protection-group group1
Example 2
host1(config)#dos-protection-group default
host1(config-dos-protection)#protocol AtmOam rate 512
host1(config-dos-protection)#protocol PppoeControl rate 512
host1(config-dos-protection)#protocol IpLocalOther rate 512
Use the no version to remove the attachment of the DoS protection group from the
interface.
See ip dos-protection-group.
Use to attach an IPv6 DoS protection group to an interface.
Example
host1(config-if)#ipv6 dos-protection-group group1
Use the no version to remove the attachment of the DoS protection group from the
interface.
See ipv6 dos-protection-group.
Use to attach a LAG DoS protection group to an interface.
Example
host1(config-if)#lag dos-protection-group group1
Use the no version to remove the attachment of the DoS protection group from the
interface.
See lag dos-protection-group.
Use to attach a PPP DoS protection group to an interface.
Example
host1(config-if)#ppp dos-protection-group group1
Use the no version to remove the attachment of the DoS protection group from the
interface.
See ppp dos-protection-group.
Chapter 7: Passwords and Security
453