Configuring The Nfs Client; References; Prerequisites; Configuration Tasks - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide

Configuring the NFS Client

References

Prerequisites

Configuration Tasks

host
302
host1#show subsystems file x8.rel
Required: 1423005
Included Subsystems:
oc12p
oc12a
ge
fe8
coc12
oc12s
Excluded Subsystems:
oc3
See show subsystems.
You can configure a virtual router on the E Series router as a Network File System (NFS)
client to provide remote file access for E Series applications that need NFS-based
transport.
The system provides NFS client support only for E Series applications designed to use
NFS-based transport. Unlike the typical implementation on UNIX workstations, the
E Series NFS client does not provide services such as mounting or unmounting of files
through the CLI.
This section describes how to configure the NFS client if you are using an E Series
application that requires NFS-based transport.
The NFS client complies with the following standards:
RFC 1094—Network File System Protocol Specification (March 1989)
RFC 1057—Remote Procedure Call Protocol Specification (June 1988)
The E Series NFS client requires a remote host to act as an NFS server. The remote host
must support NFS server protocol version 2 or higher.
To configure a virtual router as an NFS client:
Access the virtual router context.
1.
Add the remote host to the host table.
2.
Configure the remote host as an NFS server for this virtual router.
3.
Specify the E Series interface that this virtual router will use to exchange NFS
4.
communications with this server.
bytes
27882192 bytes
6840211 bytes
Copyright © 2010, Juniper Networks, Inc.