Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 98

JunosE 11.3.x System Basics Configuration Guide
Table 10: Command Mode Overview (continued)
Mode Name Use of Mode
Domain Map
Configuration
Domain Map
Tunnel Configuration
DoS Protection Group
Configuration
Drop Profile
Configuration
Explicit Path
Configuration
Flow Cache
Configuration
Global Configuration
68
Access to Mode
Configure domain maps.
Configure tunnel
parameters.
Configure parameters for
DoS protection groups.
Configure drop profiles.
Configure MPLS explicit
path parameters.
Configure parameters for
the aggregation cache.
Enable a feature or
function.
Disable a feature or
function.
Configure a feature or
function.
Exit from Mode
From Global Configuration
mode, use the aaa
domain-map command.
Prompt:
host1(config-domain-map)#
From Domain-Map
Configuration mode, use
the tunnel command.
Prompt:
host1(config-domain-m
ap-tunnel)#
From Global Configuration
Mode, use the
dos-protection-group
command.
Prompt:
host1(config-dos-group)#
From Global Configuration
mode, use the
drop-profile command.
Prompt:
host1(config-drop-profile)#
From Global Configuration
mode, specify the mpls
explicit-path name
command.
Prompt:
host1(config-expl-path)#
From Global Configuration
Mode, use the ip
flow-aggregation cache
command.
Prompt:
host1(config-flow-cache)#
From Privileged Exec
mode, use the configure
command.
Prompt:
host1(config)#
Copyright © 2010, Juniper Networks, Inc.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command twice to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command to return
to Global Configuration mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command, or press
Ctrl+z to return to Exec mode.
Use the interface command to
enter Interface Configuration
mode.