Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 184

Software for e series broadband services routers system basics configuration guide
Hide thumbs Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04:
Table of Contents

Advertisement

JunosE 11.3.x System Basics Configuration Guide
snmp-server interfaces compress
154
pppLinkInterface
pppoeInterface
slepInterface/ciscoHdlc
Use to remove interface sublayers either from all interface tables or from specific table
types, such as interface tables and interface stack tables, in the SNMP interface
configuration. If you use the snmp-server interfaces compress command on an
interface without specifying a table type, it compresses the interface in all the tables.
If you compress an interface using the table-type keyword for the first time, subsequent
uses of the snmp-server interfaces compress command without the table-type
keyword compress the interface only in the ipNetToMediaTable (not in interface tables
or interface stack tables).
Example 1—To compress all interfaces on an interface layer, PPP, use the following
command:
host1(config)#snmp-server interfaces compress ppp
Example 2—If you use the snmp-server interfaces compress command with the
table-type keyword to compress an interface, issuing the same command the next
time without specifying a table type compresses the interface only in the
ipNetToMediaTable. In the following example, the command is used with the table-type
keyword for the first time on a router to compress the Ds1 interface in interface stack
tables:
host1(config)#snmp-server interfaces compress Ds1 table-type interface-stack-tables
Subsequent use of the same command on any interface (in the following example,
Atm) on the same router without the table-type keyword compresses the interface
only in the ipNetToMedia table (not in interface or interface stack tables):
host1(config)#snmp-server interfaces compress Atm
Example 3—To compress interfaces based on the table types, interface-tables and
interface-stack-tables, use the following CLI example. In this example, the Atm
interface is compressed in interface tables (ifTables) and the Ds1 interface is
compressed in interface stack tables (ifStackTables), but none of the interfaces are
compressed in the ipNetToMediaTable.
host1(config)#snmp-server interfaces compress ?
[interfaceList]
table-type
Category of SNMP tables from which to remove
< cr >
host1(config)#snmp-server interfaces compress atm table-type ?
interface-stack-tables Compression will be applicable to
ifStackTable/ifInvStackTable/juniIfStackTable
interface-tables
Compression will be applicable to
ifTable/ifXtable/juniIfTable
host1(config)#snmp-server interfaces compress atm table-type interface-tables
host1(config)#snmp-server interfaces compress Ds1 table-type interface-stack-tables
Router#show snmp interfaces
Compressed(Removed) Interface Types :
From ipNetToMediaTable:
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Junose 11.3

Table of Contents