Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 388

JunosE 11.3.x System Basics Configuration Guide
slot erase
358
host1(config)#slot accept 7 srp
There is no no version.
See slot accept.
Use to delete the configuration of the module in the selected slot before you install a
different type of module.
This command enables you to create a fresh configuration for the module installed in
the slot.
You cannot use this command on a primary SRP module; however, you can use it on
a standby SRP module.
If you specify a slot on the E120 or E320 router that contains an SRP module, you erase
the configuration of the SC subsystem on that slot by default. You do not, however,
erase the configuration of the fabric slice that resides on the slot.
Use the srp keyword to erase only the configuration of the portion of the SC
subsystem that resides on a specified SRP module.
Use the fabric keyword to erase only the configuration of the fabric slice that resides
on the specified SRP module.
If you specify a slot that contains a line module, you erase the configuration of the line
module and the I/O modules or IOAs associated with it. To erase the configuration of
a specific IOA on the E120 or E320 router, use "adapter erase" on page 356 command.
If you specify the slot erase command to delete the configuration of the module in the
selected slot before you install a different type of module on slots that contain line
modules that are members of a high availability pair, an error message is displayed.
The error message indicates that you must deactivate high availability feature for the
applicable line modules before erasing or replacing the slot configuration. You need
to use the no mode high-availability slot command to disable high availability for the
slots in which those line modules reside.
Example 1—Erases the configuration of the module in slot 3
host1(config)#slot erase 3
Example 2—Erases the configuration of the specified SRP module and the SC subsystem
in slot 7 (applies only to E120 and E320 routers)
host1(config)#slot erase 7
Example 3—Erases the configuration of the SC on the SRP module in slot 7 (applies
only to E120 and E320 routers)
host1(config)#slot erase 7 srp
There is no no version.
See slot erase.
Copyright © 2010, Juniper Networks, Inc.