Downgrading Junose Software - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual
Software for e series broadband services routers system basics configuration guide
Hide thumbs
Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04:
- Configuration manual (304 pages) ,
- Reference manual (284 pages)
Table of Contents
Advertisement
Downgrading JunosE Software
Copyright © 2010, Juniper Networks, Inc.
Configuring from terminal or file [terminal]?
Enter configuration commands, one per line. End with CNTL/Z.
host1 (config)#no disable-autosync
host1 (config)#exit
The software is updated on the other SRP module.
After the system is configured with a 5.x.x release, newer releases are supported and can
be installed.
Downgrading JunosE Software requires factory defaults installed on the router, and can
cause NVS and configuration script incompatibilities.
CAUTION: We do not recommend that you attempt to downgrade JunosE
Software without the assistance of a Juniper Technical Assistance Center
representative. Contact the Juniper Technical Assistance Center to obtain
help.
Chapter 3: Installing JunosE Software
135
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 and is the answer not in the manual?
Questions and answers