Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 305

show terminal
Copyright © 2010, Juniper Networks, Inc.
host1#show line console 0
dsr-detect disabled
configured speed 9600, current speed 9600
exec-timeout never
See show line console 0.
Use to view parameters of the current console session.
Field descriptions
Length—Number of lines on the screen
Width—Number of characters on each line of the screen
data-character-bits—Number of bits per character
7—Setting for the standard ASCII set
8—Setting for the international character set
Speed—Speed of the console session
dsr-detect—Status of DSR signal detection
enabled—DSR signal must be detected for a user to log in to the console.
disabled—DSR signal need not be detected for a user to log in to the console.
exec-timeout—Time interval that the terminal waits for expected user input
Never—Indicates that there is no time limit
exec-banner—Status for the exec banner: enabled or disabled. This banner is
displayed by the CLI after user authentication (if any) and before the first prompt of
a CLI session.
motd-banner—Status for the MOTD banner: enabled or disabled. This banner is
displayed by the CLI when a connection is initiated.
login-timeout—Time interval during which the user must log in.
Never—Indicates that there is no time limit
Example
host1#show terminal
Length: 25 lines, Width: 80 columns
data-character-bits: 8 bits per character
Speed: 9600 bits per second
dsr-detect disabled
exec-timeout never
exec-banner enabled
motd-banner enabled
login-timeout 30 seconds
See show terminal.
Chapter 5: Managing the System
275