Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 82

JunosE 11.3.x System Basics Configuration Guide
Example 9
Example 10
Example 11
Example 12
52
Example 8 reverts one privilege group membership to its default setting. Prior to the
execution of this command, the following group memberships were in place:
group
8
9
10
11
12
Reverting privilege group 9 to its default gives it one member: privilege group 8. This
creates the circular dependency: 8 contains 12, 12 contains 11, 11 contains 10, 10 contains
9, and 9 contains 8.
host1(config)#no privilege-group membership
In Example 9, privilege group membership reverts to the default setting. All privilege
groups revert to hierarchical settings: 15 contains 14, 14 contains 13, 13 contains 12, and
so forth. Privilege group 0 is reachable from every privilege group.
host1(config)#no privilege-group membership 7
In this example, one privilege group membership reverts to its default setting. Privilege
group 7 contains group 6.
host1(config)#no privilege-group alias
In Example 11, all alias settings are removed.
host1#show privilege group
privilege privilege
group group
alias
---------- ----------
0 minUser
1 --
2 --
3 --
4 --
5 basicUser
6 dailyTroll
7 weekendAdmin
8 --
9 --
10 dailyAdmin
11 --
12 --
13 LI
member reachable
12 12,0
-- 0
9 9,0
10 10,9,0
11 11,10,9,0
directly
reachable
groups
-------- -----------------
-- --
-- 0
1 0 1
2 0 1 2
3 0 1 2 3
4 0 1 2 3 4
5 0 1 2 3 4 5
1 0 1
14 0 14
-- 0
6 0 1 2 3 4 5 6
5 0 1 2 3 4 5
5 0 1 2 3 4 5
10 0 1 2 3 4 5 6 10
all
reachable
groups *
Copyright © 2010, Juniper Networks, Inc.