Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 91

Example 1
Copyright © 2010, Juniper Networks, Inc.
host1(config)#?
aaa
access-list
arp
bandwidth
banner
baseline
boot
bulkstats
classifier-list
clns
clock
confirmations
controller
crypto
default
disable-autosync
disable-switch-on-error
do
enable
end
exception
exclude-subsystem
exit
ftp-server
help
host
hostname
interface
ip
l2tp
license
line
log
macro
map-list
memory
mpls
no
ntp
policy-list
pppoe
profile
radius
rate-limit-profile
redundancy
route-map
router
rtr
run
service
set
sleep
slot
snmp-server
sscc
telnet
Configure authentication, authorization, and
accounting characteristics
Configure an access list entry
Configure a static ARP entry
Configure slot-group bandwidth control
Define a banner line
Configure baseline operations
Configure boot time behavior
Configure bulkstats parameters
Configure a classifier list entry
Configure CLNS characteristics
Set the system's clock
Configure confirmation mode
Configure controller parameters
Configure cryptographic parameters
Set a command to its default(s)
Disable automatic synchronization of redundant
system controller file system
Disable automatic switch to redundant system
controller upon software/hardware error
Run an exec mode command (alias command run)
Configure security related options
Exit Global Configuration mode
Configure core dump
Exclude copying a subsystem from the release
Exit from the current command mode
Configure FTP Server characteristics
Describe the interactive help system
Add/modify an entry to the host table
Set the host (system) name
Enter Interface Configuration mode
Configure IP characteristics
Configure L2TP parameters
Configure licenses
Enter Line Configuration mode
Configure logging settings
Run a CLI macro
Create an NBMA static map
Configure and administer memory operations
Configure MPLS global parameters
Negate a command or set its default(s)
Configure the Network Time Protocol
Enter Policy Configuration mode
Configure PPPoE
Specify a profile
Configure RADIUS server
Enter rate limit profile configuration mode
Perform a redundancy configuration
Configure a route map
Configure a routing protocol
Configure rtr parameters
Run an exec mode command (alias command do)
Configure system-level services
Configure
Make the Command Interface pause for a specified
duration
Configure and administer slot operation
Configure SNMP parameters
The SSC Client telnet
telnet daemon configuration
Chapter 2: Command-Line Interface
61