Defining A Threshold Test - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide
172
host1(config-mgmtevent-trigger)#boolean-test event george trigger1
When specifying an event, make sure to use the exact owner name and event name.
Specify the agent on which the object resides.
4.
host1(config-mgmtevent-trigger)#agent context-name router1
You can obtain the agent context name for a virtual router from the show snmp agent
command. The agent context name is independent of the virtual router name.
Enable the trigger.
5.
host1(config-mgmtevent-trigger)#enable
Once enabled, you cannot edit an event or trigger configuration. To change an enabled
event or trigger, you must delete it and re-create it.

Defining a Threshold Test

To define a threshold test:
Define the threshold-test values that you want this trigger to use.
1.
NOTE: The rising value must always be larger than the falling value.
Entering a lower rising value than a falling value will provide invalid results
or errors.
absolute-value—Use when defining absolute threshold values
host1(config-mgmtevent-trigger)#threshold-test absolute-value rising 2000 falling
1900
delta-value—Use when defining delta threshold values
host1(config-mgmtevent-trigger)#threshold-test delta-value rising 2000 falling
1900
Define the startup threshold condition that you predict the sample to initially
2.
follow—falling, rising, risingorfalling. For example, if you are sampling a MIB value that
you know will start from zero and rise, you would specify a rising startup condition.
host1(config-mgmtevent-trigger)#threshold-test startup rising
Specify the events (rising or falling) that you want the threshold-test trigger to use
3.
by entering an event owner name and event name.
NOTE: You do not need to bind a failure event to a trigger. If you create a
failure event, if a failure occurs, and if the trigger owner and the event
owner are the same, the router sends the trap.
host1(config-mgmtevent-trigger)#threshold-test event falling sysadmin fallingtrigger
host1(config-mgmtevent-trigger)#threshold-test event rising sysadmin risingtrigger
When specifying an event, make sure to use the exact owner name and event name.
Copyright © 2010, Juniper Networks, Inc.