Command-Line Prompts; Figure 21: Command Mode Architecture - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual
Software for e series broadband services routers system basics configuration guide
Hide thumbs
Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04:
- Configuration manual (304 pages) ,
- Reference manual (284 pages)
Table of Contents
Advertisement
JunosE 11.3.x System Basics Configuration Guide
Command-Line Prompts
28
Figure 21 on page 28 illustrates the command mode architecture. Only some of the many
configuration modes are shown.
Command modes are discussed in greater detail in the section "Accessing Command
Modes" on page 66 . See the JunosE Command Reference Guide to find related command
modes for any command.
Figure 21: Command Mode Architecture
Within the CLI, the command-line prompt identifies both the hostname and the command
mode. The hostname is the name of your router; the command mode indicates your
location within the CLI system.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 and is the answer not in the manual?
Questions and answers