Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 377

slot enable
Copyright © 2010, Juniper Networks, Inc.
Use the srp keyword to disable only the portion of the SC subsystem that resides on
a specified SRP module.
Use the fabric keyword to disable only the fabric slice that resides on the specified
SRP module.
If you specify a slot that contains a line module, you disable only the line module; you
do not disable the line module and the I/O modules and IOAs associated with it. To
disable a specific IOA on the E120 or E320 Router, issue "adapter disable" on page 348
command.
Example 1—Disables the module in slot 3
host1(config)#slot disable 3
Example 2—Disables the SRP module and the SC subsystem in slot 7 (applies only to
the E120 and E320 routers)
host1(config)#slot disable 7
Example 3—Disables only the fabric slice on the SRP module in slot 7 (applies only to
E120 and E320 routers)
host1(config)#slot disable 7 fabric
There is no no version.
See slot disable.
Use to enable the module in the specified slot.
Allows you to restart the module that was installed in the slot.
You cannot use this command on a standby SRP module.
If you specify a slot on the E120 or E320 Broadband Services Routers that contains an
SRP module, you enable the SC subsystem on that slot by default. You do not, however,
enable the fabric slice that resides on the slot.
Use the srp keyword to enable only the portion of the SC subsystem that resides on
a specified SRP module.
Use the fabric keyword to enable only the fabric slice that resides on the specified
SRP module.
If you specify a slot that contains a line module, you enable only the line module; you
do not enable the line module and the I/O modules and IOAs associated with it. To
enable a specific IOA on the E120 or E320 Broadband Services Routers, use "adapter
enable" on page 348 command.
The default is enable.
Example 1—Enables the module in slot 3
host1(config)#slot enable 3
Example 2—Enables the SRP module and the SC subsystem in slot 7 (applies only to
E120 and E320 routers)
Chapter 6: Managing Modules
347