Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 240

Software for e series broadband services routers system basics configuration guide
Hide thumbs Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04:
Table of Contents

Advertisement

JunosE 11.3.x System Basics Configuration Guide
bulkstats schema subtree if-stack
bulkstats schema subtree if-stats
bulkstats schema subtree igmp
210
NOTE: If you create a collector but there is no schema for that collector,
the collector will not be active, and a schema will be created automatically
for that collector to collect if-stats for all subtree attributes.
See bulkstats schema.
Use to retrieve interface and interface column configuration information.
Retrieves statistics from ifStackTable, which stores the configured interfaces and their
stacking relationship on a router.
Example—Configures the if-stack schema
host1(config)#bulkstats schema 4 subtree if-stack
Use the no version to delete the specified schema.
See bulkstats schema subtree.
Use to retrieve interface usage data on sets of interface types.
To collect statistics for the specified counter type, use the subtreelist keyword.
To retrieve the offset from the master interval at which the record was created for the
bulk statistics interface record, use the time-offset keyword.
To collect the final statistics that may have been lost, use the
if-create-delete-time-stats keyword.
Example 1—Configures the schema to collect interface usage statistics for lower
interface
host1(config)#bulkstats schema 1 subtree if-stats subtreelist lower-interface
Example 2—Configures the schema to retrieve final statistics that may have been lost
during a higher create or delete frequency, for the specified interface
host1(config)#bulkstats schema 5 subtree if-stats if-create-delete-time-stats
interfaceType ?
atm1483
Configure bulkstats for ATM 1483 sub-interfaces
ip
Configure bulkstats for IP interfaces
mplsL2Shim
Configure bulkstats for MPLS shim Interfaces
mplsMajor
Configure bulkstats for MPLS major Interfaces
mplsMinor
Configure bulkstats for MPLS minor Interfaces
ppp
Configure bulkstats for PPP interfaces
vlan
Configure bulkstats for VLAN Sub-Interfaces
Use the no version to delete the specified schema.
See bulkstats schema subtree.
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Junose 11.3

Table of Contents