JunosE 11.3.x System Basics Configuration Guide
Example 2
Example 3
62
timing
traffic-shape-profile
virtual-router
host1(config)#ip ?
address-pool
as-path
bgp-community
community-list
debounce-time
dhcp-local
dhcp-server
domain-lookup
domain-name
dvmrp
dynamic-interface-prefix
explicit-path
extcommunity-list
ftp
http
local
multicast-routing
name-server
pim
prefix-list
prefix-tree
route
router-id
rpf-route
source-route
ssh
ttl
tunnel
vpn-id
vrf
host1(config)#ip
host1(config)#ip community-list ?
<1 - 99>
The community list
host1(config)#ip community-list
When you want to see a list of commands that begin with a particular set of characters,
type a question mark ( ? ) immediately after the last letter. Do not use a space between
the partial keyword and the ? key. For example:
host1#sh?
show shutdown
host1#sh
Configure network timing
Enter traffic shape profile configuration mode
Specify a virtual router
Configure address pool for PPP Broadband RAS
clients
Configure a path filter for AS-Paths in BGP
Format for BGP community
Configure an entry in a community list
Specify the minimum amount of time that an event
needs to be in same state before being reported
The DHCP Local Server protocol
DHCP Server for Proxy Client
Enable DNS lookup
Specify local Domain name
configure dvmrp paramaters
Specify name prefix for dynamic Ip shared
interfaces
Configure an explicit path
The extended community list
Configure FTP characteristics
Configure http server
Local IP address assignment
Enable IP multicast forwarding
Configure DNS server
Configure PIM Protocol
Configure a prefix list entry
Configure a prefix tree entry
Define a static IP route
Configure the router-id to be used
Define a static IP route for mcast RPF check
Configure source-routing capabilities
Configure SSH characteristics
Configure the default value to be used by IP for
Time-To-Live
Configure tunnel parameter
Configure the VPN ID associated with this router
Specify a VRF
Copyright © 2010, Juniper Networks, Inc.
Need help?
Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 and is the answer not in the manual?