Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 248

JunosE 11.3.x System Basics Configuration Guide
Table 29: Mapping Bulkstats Output to MIB Flies and CLI Configurations for Policy
Schema (continued)
Bulkstats Output
Column Name MIB File
ifTimeOffse juniAcctng
ifHCInMulticastPkts RFC2863
ifHCInBroadcastPkts RFC2863
218
MIB Object Name CLI Configuration
juniAcctngIfTimeOffset time-offset
ifHCInMulticastPkts in-mcast-pkts
ifHCInBroadcastPkts in-bcast-pkts
Description
-
The number of packets,
delivered by this sub-layer
to a higher (sub-)layer,
which were addressed to a
multicast address at this
sub-layer. For a MAC layer
protocol, this includes both
Group and Functional
addresses. This object is a
64-bit version of
ifInMulticastPkts
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
ifCounterDiscontinuityTime
The number of packets,
delivered by this sub-layer
to a higher (sub-)layer,
which were addressed to a
broadcast address at this
sub-layer. This object is a
64-bit version of
ifInBroadcastPkts
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
ifCounterDiscontinuityTime
Copyright © 2010, Juniper Networks, Inc.