Radius Relay Configuration Mode; Rate Limit Profile Configuration Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide

RADIUS Relay Configuration Mode

Rate Limit Profile Configuration Mode

106
In this mode, you can configure various parameters of your RADIUS relay authentication
and accounting servers.
From Global Configuration mode, type either the radius relay authentication server or
radius relay accounting server command, and press Enter.
host1(config)#radius relay authentication server
radius authentication serverhost1(config-radius-relay)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
key Configure the secret used in RADIUS client to relay server exchange
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
udp-port Configure the RADIUS relay server's udp port
In this mode, you can set parameters for an IP or L2TP rate-limit profile, which is a set of
bandwidth attributes and associated actions that become part of a policy list. The policy
list is then applied to the ingress or egress of an interface.
To create a hierarchical rate-limit-profile for an IP interface, from Global Configuration
mode type rate-limit-profile and a profileName, and add the keyword hierarchical, and
press Enter.
To create an IP rate-limit profile, from Global Configuration mode type ip
rate-limit-profile and a profileName, and press Enter.
To create an L2TP rate limit profile, from Global Configuration mode type l2tp
rate-limit-profile and a profileName, and press Enter.
NOTE: If you do not include either the ip or l2tp keywords, the system creates
an IP rate limit profile.
host1(config)#ip rate-limit-profile fm78930
host1(config-rate-limit-profile)#?
committed-action Set the committed access rate action
committed-burst Set the committed access rate burst size in Bytes
committed-rate Set the committed access rate value in bits per second
conformed-action Set the conformed access rate action
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exceeded-action Set the exceeded action
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
mask-val Set mask to be applied with mark values
Copyright © 2010, Juniper Networks, Inc.