Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 486

JunosE 11.3.x System Basics Configuration Guide
protocol weight
use canned-group
vlan dos-protection-group
456
Use to set the skip priority rate limiter for the protocol.
The specified protocol is not subject to the priority rate limiter for the priority and DoS
protection group selected.
The default sets the protocol such that it is subject to priority rate limiting.
Example
host1(config-dos-protection)#protocol IpLocalDhcpIc skip-priority-rate-limiter
Use the no version to set the value to the default, which is not to use
skip-priority-rate-limiter.
See protocol skip-priority-rate-limiter.
Use to set the weight for the protocol.
For each port compression, weight determines the effective minimum rate that each
protocol receives.
Within each port compression, the sum of the minimum rates for all protocols is equal
to or less than the priority rate.
For each priority, there is a separate rate for each DoS protection group.
Example
host1(config-dos-protection)#protocol IpLocalDhcpIc weight 100
Use the no version to set the weight to the value specified in the associated default
group.
See protocol weight.
Use to create a DoS protection group that uses a pre-programmed set of parameters.
Use the revert keyword to return the values to the canned group values
Example
host1#use canned-group group1
Use the no version to associate the group with the default canned group settings.
See use canned-group.
Use to attach a VLAN DoS protection group to an interface.
Example
host1(config-if)#vlan dos-protection-group
Use the no version to remove the attachment of the DoS protection group from the
interface.
See vlan dos-protection-group.
Copyright © 2010, Juniper Networks, Inc.