Booting The System; Platform Considerations; Configuring Your System For Booting - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

CHAPTER 9

Booting the System

Platform Considerations

Configuring Your System for Booting

Copyright © 2010, Juniper Networks, Inc.
This chapter provides information about booting your E Series router.
NOTE: The type of file you must always use for booting your system is a
software release file with the extension .rel.
This chapter contains the following sections:
Platform Considerations on page 495
Configuring Your System for Booting on page 495
Rebooting Your System on page 500
Operations in Boot Mode on page 503
Displaying Boot Information on page 504
System booting is supported on all E Series routers.
For information about the modules supported on E Series routers:
See the ERX Module Guide for modules supported on ERX7xx models, ERX14xx models,
and the ERX310 Broadband Services Router.
See the E120 and E320 Module Guide for modules supported on the E120 and E320
Broadband Services Routers.
Juniper Networks delivers your E Series router already set up with a factory default
configuration and a software release (.rel) file. You can, however, create a new
configuration file (.cnf) and select a different software release file to use in future reboots
of your router. When you reboot your router, you can use:
An existing configuration file to be used each time the system reboots
An existing configuration file limited to a single reboot
495