Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 287

no boot backup
no boot subsystem
no boot backup subsystem
no boot force-backup
!
! Note: The following commands are here to ensure that all virtual routers and
! vrfs are created before other commands that may need to reference them.
! These commands will be repeated further on as each virtual router and vrf
! has its configuration presented.
!
virtual-router default
virtual-router boston
!
ip vrf vpna
virtual-router vrA
!
hostname host1
exception protocol ftp anonymous null
!
controller t1 6/0
channel-group 2 timeslots 1,3-8,10 speed 64
.
.
.
!
virtual-router vrA
aaa authentication ppp default radius
aaa accounting ppp default radius
!
ip address-pool local
interface null 0
ip bgp-community new-format
no ip source-route
!
snmp-server
!
! End of generated configuration script.
host1# show configuration interface serial 4/0
interface atm 4/0
atm vc-per-vp 1024
atm uni-version 3.0
!
interface atm 4/0.1 point-to-point
profile pppoe myProfile
qos-profile myQosProfile
!
interface atm 4/0.2 point-to-point
qos-profile myQosProfile
ip description TestIP
!
interface atm 4/0.3 point-to-point
host1# show configuration category system file-system
boot config running-configuration
boot system m.rel
no boot backup
Copyright © 2010, Juniper Networks, Inc.
Example using interface keyword:
Example using category keyword:
Chapter 5: Managing the System
257