Qos Profile Configuration Mode; Qos Shared Shaper Control Configuration - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide

QoS Profile Configuration Mode

QoS Shared Shaper Control Configuration

104
In this mode, you can specify queue profiles and scheduler profiles in combination with
interface types.
From Global Configuration mode, type the qos-profile command followed by a
QosProfileName, and press Enter.
host1(config)#qos-profile testabc
host1(config-qos-profile)#?
atm ATM interface
atm-vc ATM-VC interface
bridge Bridge interface
default Set a command to its default(s)
do Run an exec mode command (alias command run)
ethernet Ethernet interface
exit Exit from the current command mode
fr-vc Frame Relay subinterface
help Describe the interactive help system
ip IP interface
ip-tunnel IP FROM-tunnel interface
l2tp-tunnel L2tp FROM-tunnel interface
log Configure logging settings
lsp Lsp (MPLS) interface
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
serial Serial interface
server-port Server Port interface
sleep Make the Command Interface pause for a specified duration
svlan Stacked VLAN subinterface
vlan VLAN subinterface
In this mode, you can configure variables within the simple shared shaper algorithm to
control the minimum dynamic rate for all simple shared shapers on the router.
From Global Configuration mode, type the qos-shared-shaper-control command and
press Enter.
host1(config)#qos-shared-shaper-control
host1(config-qos-shared-shaper-control)#?
convergence-factor
default
do
exit
help
log
macro
maximum-voql
minimum-dynamic-rate-percent
no
reaction-factor
Configure how quickly the simple shared shaper
converges to a calculated rate
Set a command to its default(s)
Run an exec mode command (alias command run)
Exit from the current command mode
Describe the interactive help system
Configure logging settings
Run a CLI macro
Configure the simple shared shaper's maximum
virtual output queue length
Configure the minimum dynamic rate for a simple
shared shaper as a percentage of the
shared-shaping-rate
Negate a command or set its default(s)
Configure how the simple shared shaper reacts
to changes in measured rate
Copyright © 2010, Juniper Networks, Inc.