Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 226

JunosE 11.3.x System Basics Configuration Guide
196
active—Receiver is properly configured and currently active
notInSvc—Receiver has been decommissioned by a management client
notReady—Receiver does not have enough configuration information to go active
error—Configuration or operational error
Status
Success
Copy source does not exist or is unreachable
Copy failed
File in use
Virtual Router Groups:
Collector—Number that identifies the particular data collector, in the range 1–65535
Virtual-Routers—Set of virtual router names (up to 64 names)
Example
host1#show bulkstats
AdminStatus: enabled
OperStatus: enabled
Interface Description Setting: industry-common
File Format: CR+LF
Current Time: TUE AUG 15 2002 15:54:20 UTC
Intervals PrimaryXfers PrimaryFails SecondaryXfers SecondaryFails
--------- ------------ ------------ -------------- --------------
0 0
BulkStats Collector Information:
Index CurrSize
----- --------
1 490
2 0
Index Primary-Receiver
----- ----------------
1 1
2 not defined
Index Interval Start Time
----- ---------------------------- -------------------------
1 TUE AUG 15 2000 15:52:33 UTC TUE AUG 15 2000 16:02:33 UTC
2 Not started
Schema Information:
Index Subtree
----- -------------------------------------------------
1 ifStats
0 0
MaxSize Intrvl Mode
-------- ------ --------- --------
3670016 600 periodic
3670016 360 periodic
Second-Receiver
---------------
not defined
not defined
Interval Stop Time
N/A
Copyright © 2010, Juniper Networks, Inc.
0
XferMode State
-------
manual inProg
manual notReady
Last Transfer Failure
--------------------