References; Appendix B References; Rfcs; Table 55: E Series Rfcs - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

Software for e series broadband services routers system basics configuration guide
Hide thumbs Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04:
Table of Contents

Advertisement

APPENDIX B

References

RFCs

Copyright © 2010, Juniper Networks, Inc.
This document lists RFCs, draft RFCs, other software standards, hardware standards,
and other references that provide information about the protocols and features supported
by the system.
RFCs on page 559
Draft RFCs on page 574
Other Software Standards on page 577
Hardware Standards on page 580

Table 55: E Series RFCs

Reference
RFC 4951—Fail Over Extensions for Layer 2 Tunneling Protocol (L2TP)
"failover" (August 2007)
RFC 4893—BGP Support for Four-octet AS Number Space (May 2007)
RFC 4816—Pseudowire Emulation Edge-to-Edge (PWE3) Asynchronous
Transfer Mode (ATM) Transparent Cell Transport Service (February
2007)
RFC 4875—Extensions to Resource Reservation Protocol - Traffic
Engineering (RSVP-TE) for Point-to-Multipoint TE Label Switched
Paths (LSPs) (May 2007)
RFC 4762—Virtual Private LAN Service (VPLS) Using Label Distribution
Protocol (LDP) Signaling (January 2007)
RFC 4684—Constrained Route Distribution for Border Gateway
Protocol/MultiProtocol Label Switching (BGP/MPLS) Internet Protocol
(IP) Virtual Private Networks (VPNs) ( 2006)
RFC 4679—DSL Forum Vendor-Specific RADIUS Attributes
(September 2006)
Protocol or Feature
L2TP
BGP
MPLS
MPLS
VPLS
BGP/MPLS VPNs
RADIUS
559

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents