Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 203

agent context-name
boolean-test
Copyright © 2010, Juniper Networks, Inc.
Specify the agent on which the object resides.
4.
host1(config-mgmtevent-trigger)#agent context-name router1
You can obtain the agent context name for a virtual router from the show snmp agent
command. The agent context name is independent of the virtual router name.
Enable the trigger.
5.
host1(config-mgmtevent-trigger)#enable
Once enabled, you cannot edit an event or trigger configuration. To change an enabled
event or trigger, you must delete it and re-create it.
Use to specify the virtual router SNMP agent on which you want to poll MIB objects.
The default is the current context (virtual router).
The contextName value is the virtual router number in the order the virtual router was
created (for example, router1, router2, and so on). Use the show snmp agent command
to obtain the context name for the virtual router.
Use the wildcard keyword to specify that the context name is a wildcard value.
NOTE: Use caution when assigning wildcards. Wildcards can rapidly use
up trigger resources.
Use the limit keyword to specify the maximum number of agents to be polled.
Example 1
host1(config-mgmtevent-trigger)#agent context-name router1 wildcard
Example 2
host1(config-mgmtevent-trigger)#agent context-name router1 wildcard limit 15
NOTE: SNMP server security defaults to no access. When using a separate
virtual router, you must use the snmp-server security command and provide
read or read-write access to other virtual routers.
Use the no version to return to the default context (virtual router).
See agent context-name.
Use to define Boolean test values for the trigger that you are configuring, including
comparison settings, a Boolean value, a startup condition, and binding an event to the
Boolean-test trigger.
Example 1—Specifying a comparison setting
Chapter 4: Configuring SNMP
173