Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 105

Table 10: Command Mode Overview (continued)
Mode Name Use of Mode
RADIUS Configuration
RADIUS Relay
Configuration
Rate Limit
Profile Configuration
Redundancy
Configuration
Remote Neighbor
Configuration
Route Map Configuration
Copyright © 2010, Juniper Networks, Inc.
Access to Mode
Configure Broadband
Remote Access Server
(B-RAS) parameters.
Configure RADIUS relay
server parameters.
Configure an IP or L2TP
rate limit parameters.
Configure high availability
(stateful SRP
switchover).
Configure remote
neighbor parameters for
OSPF, PIM, or RIP.
Configure routing tables
and source and
destination information.
Exit from Mode
From Global Configuration
mode, use a radius server
command.
Prompt:
host1(config-radius)#
From Global Configuration
mode, use the radius relay
server command.
Prompt:
host1(config-radius-relay)#
To create an IP rate limit
profile, from Global
Configuration mode use
the ip rate-limit-profile
command.
To create an L2TP rate
limit profile, from Global
Configuration mode use
the l2tp rate-limit-profile
command.
Prompt:
host1(config-rate-limit-
profile)#
From Global Configuration
mode, use the redundancy
command.
Prompt:
host1(config-redundancy)#
From Router Configuration
mode, use the
remote-neighbor
command.
Prompt:
host1(config-router-rn)#
From Global Configuration
mode, use the route-map
command.
Prompt:
host1(config-route-map)#
Chapter 2: Command-Line Interface
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command twice to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
75