Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 230

JunosE 11.3.x System Basics Configuration Guide
show bulkstats statistics
200
notReady—Receiver does not have enough configuration information to go active
error—Configuration/operational error
Status
Success
Copy source does not exist or is unreachable
Copy failed
File in use
Example
host1#show bulkstats receiver
Index RemoteFileName
----- ----------------------------------------------
1 f:/upload/bulkStas.sts
Index State
----- --------
1 notReady
See show bulkstats receiver.
Use to display bulk statistics counters.
Field descriptions
AdminStatus—Administrative status of the bulk statistics application
OperStatus—Operational status of the bulk statistics application
HdwDetects—Number of times the bulk statistics application detected a line module
bulkstat collector's presence
HdwCollectorCreates—Number of line module collectors created
CollectorCreateReqs—Number of times the bulk statistics application requested
the creation of a line module collector
CollectorStopReqs—Number of times the bulk statistics application requested the
line module collectors to stop
CollectorDeleteReqs—Number of times the bulk statistics application requested the
deletion of a line module collector
CollectorStarts—Number of times the bulk statistics collector has started
CollectorIncompleteCfgs—Number of times the bulk statistics collector attempted
to start a collector, but failed because the collector's configuration was incomplete
Status
---------------------------------------------
Copy source does not exist or is unreachable
Copyright © 2010, Juniper Networks, Inc.