Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 249

Table 29: Mapping Bulkstats Output to MIB Flies and CLI Configurations for Policy
Schema (continued)
Bulkstats Output
Column Name MIB File
ifHCOutMulticastPkts RFC2863
ifHCOutBroadcastPkts RFC2863
ifHCInMulticastOctets -
ifHCOutMulticastOctets -
Copyright © 2010, Juniper Networks, Inc.
MIB Object Name
ifHCOutMulticastPkts
ifHCOutBroadcastPkts
-
-
Table 30 on page 220 shows the mapping between the bulkstats output and the CLI and
MIBs for QoS schema.
Chapter 4: Configuring SNMP
CLI Configuration Description
out-mcast-pkts The total number of
packets that higher-level
protocols requested be
transmitted, and which
were addressed to a
multicast address at this
sub-layer, including those
that were discarded or not
sent. For a MAC layer
protocol, this includes both
Group and Functional
addresses. This object is a
64-bit version of
ifOutMulticastPkts
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
ifCounterDiscontinuityTime
out-bcast-pkts The total number of
packets that higher-level
protocols requested be
transmitted, and which
were addressed to a
broadcast address at this
sub-layer, including those
that were discarded or not
sent. This object is a 64-bit
version of
ifOutBroadcastPkts
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
ifCounterDiscontinuityTime
in-mcast-octets Multicast octets received
out-mcast-octets Multicast octets sent
219