Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 274

JunosE 11.3.x System Basics Configuration Guide
disable
do
enable
244
Example 2
host1#configure
Configuring from terminal or file [terminal]? file
File name: system1.scr
Proceed with configure? [confirm]
host1(config)#
There is no no version.
See configure.
Use to exit Privileged Exec mode and return to User Exec mode.
Use to move to a lower Privileged Exec mode level without returning to User Exec
mode. Specifying a privilege level after the disable command changes the Privileged
Exec mode to the lower level that you specify; you do not return to User Exec mode.
Example 1
host1#disable
host1>
Example 2
host1#show privilege
Privilege level is 10
host1#disable 5
host1#show privilege
Privilege level is 5
There is no no version.
See disable.
Use to issue an Exec mode command from any CLI configuration command mode.
Example
host1(config)#do show configuration | begin interface
The do command functions the same as the run command.
There is no no version.
See do.
Use to move from User Exec to Privileged Exec mode.
Privileged Exec mode allows you to access all other user interface modes. From here
you can configure, monitor, and manage all aspects of the router.
You can access the Privileged Exec commands using one of 16 levels of command
privilege. If you do not enter a privilege level and you are not accessing the router
through a RADIUS authentication account, the default CLI access level is 10. For
Copyright © 2010, Juniper Networks, Inc.