Parent Group Configuration Mode; Policy List Configuration Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide

Parent Group Configuration Mode

Policy List Configuration Mode

100
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
In this mode, you can configure a parent group in a hierarchy.
From Global Configuration mode, type the parent-group command and specify a
parentGroupName, and press Enter.
host1(config)#parent-group group1
host1(config-parent-group)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
next-parent Specify the next parent group to call in hierarchy
no Negate a command or set its default(s)
rate-limit-profile Specify a hierarchical rate limit profile
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified
In this mode, you can configure a policy list—that is, a set of rules—that you can attach
to an interface. You can modify a policy list and update it wherever the policy list is used
in the configuration.
To create a policy list, from Global Configuration mode type policy-list command
preceded by the type of policy and press Enter. For example,
host1(config)#l2tp policy-list routeL2tp100
NOTE: If you do not include the type of policy, the system creates an IP policy
list.
host1(config)#ip policy-list routeForABBCCorp
host1(config-policy-list)#?
classifier-group
color
default
do
exit
filter
forward
help
log
macro
mark
next-hop
next-interface
no
rate-limit-profile
run
Specify the classifier list
Create a color policy
Set a command to its default(s)
Run an exec mode command
Exit from the current command mode
Create a filter policy
Create a forward policy
Describe the interactive help system
Configure logging settings
Run a CLI macro
Create a set TOS byte policy
Create a next-hop policy
Create a next-interface policy
Negate a command or set its default(s)
Create a rate-limit policy
Run an exec mode command (alias command do)
Copyright © 2010, Juniper Networks, Inc.