Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 482

JunosE 11.3.x System Basics Configuration Guide
bridge1483 dos-protection-group
dos-protection-group
ethernet dos-protection-group
frame-relay dos-protection-group
hdlc dos-protection-group
452
Use to attach a bridge 1483 DoS protection group to an interface.
Example
host1(config-if)#bridge1483 dos-protection-group group1
Use the no version to remove the attachment of the DoS protection group from the
interface.
See bridge1483 dos-protection-group.
Use to create a DoS protection group and enter DoS Protection Group Configuration
mode.
A group named default always exists.
Example
host1(coonfig)#dos-protection-group default
Use the no version to remove the DoS protection group.
See dos-protection-group.
Use to attach an Ethernet DoS protection group to an interface.
Example
host1(config-if)#ethernet dos-protection-group group1
Use the no version to remove the attachment of the DoS protection group from the
interface.
See ethernet dos-protection-group.
Use to attach a Frame Relay DoS protection group to an interface.
Example
host1(config-if)#frame-relay dos-protection-group group1
Use the no version to remove the attachment of the DoS protection group from the
interface.
See frame-relay dos-protection-group.
Use to attach an HDLC DoS protection group to an interface.
Example
host1(config-if)#hdlc dos-protection-group group1
Copyright © 2010, Juniper Networks, Inc.