Monitoring Flash Cards - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

Monitoring Flash Cards

show flash
Copyright © 2010, Juniper Networks, Inc.
Please Wait...
Checking Free Space
Please Wait...
PCMCIA Card Scan Detected Errors in:
\\images\ct1Diag\ct1Diag3c440e9e.cmp
PCMCIA Card Scan successful!
:boot##flash-disk scan repair
WARNING: Execution of this command may cause the contents of the Flash
disk to be modified.
Proceed with Flash disk scan? [confirm]
Srp PCMCIA Card Scan...
Boot Block OK
File Allocation Table OK
Root Directory OK
Checking File Space
Please Wait...
Checking Free Space
Please Wait...
PCMCIA Card Scan Removed:
\\images\ct1Diag\ct1Diag3c440e9e.cmp
PCMCIA Card Scan successful!
:boot##flash-disk scan
Proceed with Flash disk scan? [confirm]
Srp PCMCIA Card Scan...
Boot Block OK
File Allocation Table OK
Root Directory OK
Checking File Space
Please Wait...
Checking Free Space
Please Wait...
PCMCIA Card Scan successful!
There is no no version.
See flash-disk scan.
Use the show nvs command to monitor the status of NVS on the primary SRP module.
Use the show flash command to view information about the flash card.
Use to display information about the flash card.
Field descriptions
Active System Controller—Information for flash cards on the active SRP module
disk0—Flash card installed in slot 0 of the SRP module
disk1—Flash card installed in slot 1 of the SRP module; available only on SRP modules
for the E120 and E320 routers
Manufacturer—Name of manufacturer of the installed flash card
Chapter 6: Managing Modules
377