Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 359

show hosts
show memory-management protection
Copyright © 2010, Juniper Networks, Inc.
Fabric scheduler weights: multicast = 1 , unicast = 8
See show fabric weights.
Use to display a list of configured network servers.
Field descriptions
Static Host Table—Information about the connected static hosts
name—Name of the host
ip address—IPv4 or IPv6 address of the host
type of host—Type of host; for example, ftp means an FTP server
NFS Host Table—Information about connected NFS servers
name—Name of the NFS server
userid—Identity for the user
groupid—Identity for the group
Example
host1#show hosts
Static Host Table
-----------------
name ip address
---- -----------
host1 10.2.0.124
hFtp 10.5.6.7
hTftp 10.5.6.7
Static Host Table
-----------------
name ip address
----- -------------------------------------
george 1111:2222:3333:4444:5555:6666:7777:8888
dsw 10.10.121.42
deab 10.6.128.12
mFtp 10.10.121.11
mTftp 10.10.121.11
mary 10.10.121.11
sd 10.10.121.80
NFS Host Table
--------------
name userid groupid
---- ------ -------
deab 2001 100
See show hosts.
Use to display information about memory management protection of the router.
You can use this command only in the support mode and it is not user configurable.
Chapter 5: Managing the System
type
----
ftp
ftp
tftp
type
----
ftp
ftp
ftp
ftp
tftp
ftp
ftp
329