Upgrading Junose Software; Upgrading Software Remotely Through Telnet Or Ftp; Upgrading Software From An Nvs Card; Upgrading A System That Contains One Srp Module - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

Software for e series broadband services routers system basics configuration guide
Hide thumbs Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04:
Table of Contents

Advertisement

Upgrading JunosE Software

Upgrading Software Remotely Through Telnet or FTP

Upgrading Software from an NVS Card

Copyright © 2010, Juniper Networks, Inc.
Your software upgrades may be available remotely through Telnet or FTP, or may be
delivered on a new NVS card. Depending on how you access the software updates, there
are two different procedures to follow. See the appropriate section for instructions:
"Upgrading Software Remotely Through Telnet or FTP" on page 133
"Upgrading Software from an NVS Card" on page 133
Follow these steps to upgrade your system software remotely:
Copy the new release to your system (using Telnet of FTP).
1.
Install and arm the release from the config# prompt using the normal upgrade
2.
procedures as described in this chapter.
Reload and configure the software.
3.
Release 5.1.1 or lower-numbered releases only support application images up to 172 MB.
To install larger application images for Release 6.0.0 and higher-numbered releases,
you must first install Release 5.1.2 (or the highest-numbered 5.x.x release). This enables
the system to support application images greater than 172 MB. For example, you cannot
go from Release 5.1.1 to Release 7.2.0 without first upgrading to Release 5.1.2 when you
upgrade the software from an NVS card. See Table 15 on page 133.

Table 15: Release Compatibility

JunosE Release
5.1.1 or lower-numbered
release
5.1.2 or higher-numbered
release
7.2.0 or higher-numbered
release
Follow these steps to upgrade your system software when the software is on an NVS
card. The procedure you use depends on the number of SRP modules in the system.

Upgrading a System That Contains One SRP Module

If the system contains only one SRP module, you must power off the system before you
upgrade the NVS card.
Highest Release Able
to Load
Cannot Load
5.3.5p0-2 or the
6.x.x or
highest-numbered 5.x.x
higher-numbered
release
release
No limitation
Not applicable
No limitation
Not applicable
Chapter 3: Installing JunosE Software
Maximum
Application
Image
~172 MB
~234 MB
~256 MB
133

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents