Control Plane Configuration Mode; Controller Configuration Mode; Dhcp Local Pool Configuration Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

Control Plane Configuration Mode

Controller Configuration Mode

DHCP Local Pool Configuration Mode

Copyright © 2010, Juniper Networks, Inc.
mask-value Mask for all TOS values applied by the color-mark profile
no Negate a command or set its default(s)
red-mark Apply TOS mark to IP packets classified Red by the rate limit
hierarchy
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
yellow-mark Apply TOS mark to IP packets classified Yellow by the rate limit
hierarchy
In this mode, you can configure policing for a specific protocol.
From Global Configuration mode, type the control-plane command and press Enter.
host1(config)#control-plane
host1(config-control-plane)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
policer Configure policing
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
You can configure physical interfaces such as a T3 in Controller Configuration mode.
From Global Configuration mode, type the appropriate controller command and its
attributes, and then press Enter.
host1(config)#controller t3 9/1
host1(config-controll)#
host1(config)#controller ?
e1 Configure a channelized E1 controller
e3 Configure a E3 controller
sonet Configure a Sonet controller
t1 Configure a channelized T1 controller
t3 Configure a T3 controller
In this mode, you can configure DHCP local pools. For example, you can specify a DNS
or NetBIOS server.
From Global Configuration mode, type the command ip dhcp-local pool and a poolName,
and then press Enter.
host1(config)#ip dhcp-local pool charlie
host1(config-dhcp-local)#?
default
default-router
dns-server
do
Set a command to its default(s)
The default-router to use for this pool
The dns-server to use for this pool
Run an exec mode command (alias command run)
Chapter 2: Command-Line Interface
85