Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 243

Table 29: Mapping Bulkstats Output to MIB Flies and CLI Configurations for Policy
Schema (continued)
Bulkstats Output
Column Name MIB File
ifType RFC1213
usdIfType juniIf
ifIndex RFC1213
IfStatsReportState -
ifHCInOctets RFC2863
Copyright © 2010, Juniper Networks, Inc.
MIB Object Name CLI Configuration
ifType -
juniIfType -
ifIndex -
- -
ifHCInOctets in-octets
Chapter 4: Configuring SNMP
Description
The type of interface.
Additional values for ifType
are assigned by the Internet
Assigned Numbers
Authority (IANA), through
updating the syntax of the
IANAifType textual
convention
Identifies the type of this
interface
A unique value, greater than
zero, for each interface. It is
recommended that values
are assigned contiguously
starting from 1. The value for
each interface sub-layer
must remain constant at
least from one
re-initialization of the
entity's network
management system to the
next re- initialization
Report State:
IfStatsReportInterim =
Interim Accounting data
The total number of octets
received on the interface,
including framing
characters. This object is a
64-bit version of ifInOctets
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
ifCounterDiscontinuityTime
213