Clearing Lines - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide

Clearing Lines

clear line
248
access-class—Access class associated with the vty line
data-character-bits—Number of bits per character
7—Setting for the standard ASCII set
8—Setting for the international character set
exec-timeout—Time interval that the terminal waits for expected user input
Never—Indicates that there is no time limit
exec-banner—Status for the exec banner: enabled or disabled. This banner is
displayed by the CLI after user authentication (if any) and before the first prompt of
a CLI session.
motd-banner—Status for the MOTD banner: enabled or disabled. This banner is
displayed by the CLI when a connection is initiated.
login-timeout—Time interval during which the user must log in.
Never—Indicates that there is no time limit
Example
host1#show line vty 0
no access-class in
data-character-bits 8
exec-timeout 3w 3d 7h 20m 0s
exec-banner enabled
motd-banner enabled
login-timeout 30 seconds
See show line vty.
Use the clear line command to clear any line on the system (vty or console). Using this
command terminates any service, such as an FTP session, on this line and closes any
open files.
Use to remove any services on a line and close any files opened as a result of services
on that line.
You can specify the absolute number to clear any line. For each line on the system, the
absolute number is listed in the line number field of the show users command output.
You can specify the line type and the relative number to clear a specific type of line.
For each line on the system, the relative number is listed in the line name field of the
show users command output.
Example 1
host1#clear line 2
Copyright © 2010, Juniper Networks, Inc.