Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 225

Copyright © 2010, Juniper Networks, Inc.
Interval Start Time—Start of current interval of bulk collections. The collector
began collecting bulk statistics at this time.
Interval Stop Time—End of current interval of bulk collections.
Schema Information:
Index—Index number of the schema
Subtree—Type of bulk statistics schema configured on the collector: if-stack,
if-stats, policy, QoS, or system
CollectorIndex—Bulk statistics collector index number
Create-Delete Time Stats—State of final statistics collection (enabled or disabled)
Create-Delete Interface Type—Interface type associated with final statistics
collection (ATM 1483, IP, PPP)
State
active—Schema is properly configured and currently active
notInSvc—Schema has been decommissioned by a management client
notReady—Schema does not have enough configuration information to go active
error—Configuration or operational error
Subtree List—Types of statistics the schema is configured to receive
Interface Types:
Index—Index number of the interface type entry
Type—Interface type for which bulk statistics collection is configured
CollectorIndex—Index number of the collector to which the interface type applies
State
active—Interface type is properly configured and currently active
notInSvc—Interface type has been decommissioned by a management client
notReady—Interface type does not have enough configuration information to
go active
error—Configuration or operational error
Receiver Information:
Index—Index number of the receiver
RemoteFileName—Hostname, path, and filename of the remote FTP server
State
Chapter 4: Configuring SNMP
195