Cli Command Exceptions; Cli Keyword Mapping - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide
privilege-group membership
privilege-group membership clear

CLI Command Exceptions

CLI Keyword Mapping

54
Use to give the privilege group name alias to the privilege group.
Example
host1(config-if)#privilege-group alias
Use the no version to remove the privilege group alias.
See privilege-group alias.
Use to add the member group to or remove the member group from the privilege group.
Example
host1(config-if)#privilege-group membership
Use the no version to restore one or all privilege groups to the default settings. When
all privilege groups are reset to the default settings, the privilege group membership is
hierarchical.
See privilege-group membership.
Use to clear a privilege group or all members from a privilege group.
Example
host1(config-if)#privilege-group membership clear
There is no no version.
See privilege-group membership clear.
Changing command privilege levels can be a powerful security tool. However, changing
the command privilege for some commands could render the CLI unusable and require
you to reboot the router. To eliminate this possibility, the CLI does not allow you to remap
the following commands:
disable
enable
exit
help
privilege
support
You cannot change the privilege level of keywords that are separated from the command
string by a parameter in the command sequence. In other words, once the privilege
algorithm reaches a parameter, the privilege algorithm that maps the commands to the
Copyright © 2010, Juniper Networks, Inc.