Profile Configuration Mode; Qos Interface Set Configuration Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide

Profile Configuration Mode

QoS Interface Set Configuration Mode

102
From Global Configuration mode, type the pppoe-service-name-table command followed
by an alphanumeric table name of up to 32 characters, and press Enter.
host1(config)#pppoe-service-name-table serviceTable1
host1(config-pppoe-service-name-table)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
service Configure service-name table entries
sleep Make the Command Interface pause for a specified duration
In this mode, you can configure a profile to subsequently configure dynamic IP interfaces.
From Global Configuration mode, type the profile command followed by a profile name
of up to 80 characters, and press Enter.
host1(config)#profile germany78
host1(config-profile)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
ip Configure IP characteristics
l2tp Configure L2TP characteristics
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
ppp Configure PPP parameters
pppoe Pppoe information
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
In this mode, you can can configure QoS interface sets.
From Global Configuration mode, type the qos-interface-set command followed by an
interfaceSetName, and press Enter.
host1(config)#qos-interface-set video
host1(config-interface-set)#?
default Set a command to its default(s)
do
exit
help
log
macro
member-interface-type
no
qos-interface-parent
qos-parameter
qos-profile
Run an exec mode command (alias command run)
Exit from the current command mode
Describe the interactive help system
Configure logging settings
Run a CLI macro
Define the member interface type of the interface set
Negate a command or set its default(s)
Select a QoS interface super set as the parent of this
interface.
Instantiate a QoS parameter for this interface
Attach/Detach a qos-profile
Copyright © 2010, Juniper Networks, Inc.