Responding To Prompts - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

confirmations explicit
Copyright © 2010, Juniper Networks, Inc.
aaa delimiter realmName "/"
hostname host1
no aaa new-model
no service ctrl-x-reboot
no service password-encryption
no baseline show-delta-counts
clock timezone UTC 0 0
no exception dump
exception protocol ftp anonymous null
line vty 4
exec-timeout 0 0
exec-banner
motd-banner
timeout login response 30
data-character-bits 8
no login
log engineering
log verbosity low
no log severity
log verbosity low NameResolverLog
log verbosity low aaaAtm1483Cfg
log verbosity low aaaEngineGeneral
log verbosity low aaaServerGeneral
log verbosity low aaaUserAccess
log verbosity low addressServerGeneral
log verbosity low atm
log verbosity low atm1483
log verbosity low atmAal5
log verbosity low bgpConnections
log verbosity low bgpDampening
log verbosity low bgpEng1
--More--

Responding to Prompts

For some actions, the system prompts you for a response. The acceptable default
responses are the following:
You can press y or Enter to agree with the prompt and continue.
You can press any other key to disagree with the prompt and cancel the action.
You can use the confirmations explicit command to require a more explicit response
to CLI prompts.
Use to require an explicit response to a CLI prompt, as follows:
To agree with the prompt and continue, you must type y and press Enter, type ye
and press Enter, or type yes and press Enter.
To disagree with the prompt and cancel the action, you must type n and press Enter
or type no and press Enter.
Pressing Enter alone, or entering any other characters, is not an acceptable response,
and the CLI will repeat the prompt.
Chapter 2: Command-Line Interface
43