Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 280

JunosE 11.3.x System Basics Configuration Guide
Example 1
250
Table 31: Output Locations for Layer 2 and Layer 3 Interface
Configurations (continued)
Layer 2 Only
Format Interfaces
Format Entire configuration
2 appears in the default
router output
The following examples show the differences between format 1 and format 2 output:
Format 1 output
virtual-router default
...
interface null 0
interface loopback 0
ip address 127.0.0.1 255.0.0.0
!
interface ip shAtm50126
ip share-interface atm 5/0.126
!
interface ip MikeShare2
ip share-interface atm 5/1.1
!
interface atm 5/0
interface atm 5/0.100 point-to-point
atm pvc 100 0 100 aal5snap 0 0 0
encapsulation pppoe
pppoe sessions 1
!
interface atm 5/0.100.1
encapsulation ppp
ppp authentication chap
ip address 102.0.1.1 255.255.255.0
!
interface atm 5/0.102 multipoint
atm pvc 1021 0 1021 aal5snap 0 0 0
atm pvc 1022 0 1022 aal5snap 0 0 0
atm pvc 1023 0 1023 aal5snap 0 0 0
ip address 102.0.2.1 255.255.255.0
!
interface atm 5/0.103 point-to-point
atm pvc 103 0 103 aal5snap 0 0 0
encapsulation bridge1483
ip address 100.0.0.1 255.255.255.0
pppoe
!
pppoe subinterface atm 5/0.103.1
encapsulation ppp
ppp authentication pap
ip address 100.0.1.1 255.255.255.0
!
interface atm 5/0.104 point-to-point
atm pvc 104 0 104 aal5snap 0 0 0
ip address 150.0.1.1 255.255.255.0
ipv6 address 2000:0:17::1/60
!
Layer 2 and Layer 3
Layer 3 Only Interfaces Combination Interfaces
Entire configuration Layer 2 configuration appears in
appears in the layer 3 the default router output; layer
virtual router output 3 configuration appears in the
layer 3 virtual router output
Copyright © 2010, Juniper Networks, Inc.