Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 364

JunosE 11.3.x System Basics Configuration Guide
show reboot-history
334
Example 2
host1#show processes memory virtual-router
*** Memory usage summary (by router, 4 total) ***
application: *
router: *
current
rtr size utilization headroom
--------- ------- ----------- --------
_unassoc_ (40M)
default (339K)
test (366K)
vr5 (327K)
--------- ------- ----------- --------
Total: 41M
Example 3
host1#show processes memory virtual-router vr5 application ip
*** Memory usage summary (by VRF) ***
application: ip
router: vr5
current
vrf size utilization headroom
--- ------- ----------- --------
vr5 (19K)
See show processes memory.
Use to display the history of system and module resets.
You can display the current reboot.hty file or a saved reboot history file.
If you have a redundant router, it can be convenient to copy the redundant module's
reboot.hty file to another filename for viewing with this command.
Field descriptions
Entry—Number of entry in the reboot history; numbers range from lowest (most
recent reset) to highest (oldest reset)
time of reset—Timestamp for reset
run state—State of system at reset
image type—Type of image running when the record is written
boot—Module is running the boot file
diagnostics—Module is running the diagnostics file
application—Module is running the software file
7% 99%
23% 100%
23% 100%
18% 100%
7% 99%
48% 100%
Copyright © 2010, Juniper Networks, Inc.