O Bus Service - ABB ACS880 Firmware Manual

640 Parameters
No. Name / Range /
Selection
207 I/O bus service
207.1 Node ID number
1...99
207.2 Fan reset selection
b0
b1
b2
b3
b4...15 Reserved
0000h...FFFFh
207.3 Command selection
207.10 Service request
trigger
207.11 Fan 1 data
0.00 ...
2147483640.00
207.12 Fan 2 data
0.00 ...
2147483640.00
Description
Distributed I/O bus settings.
This group is only visible with a BCU control unit.
This group contain parameters related to the
distributed I/O bus, which is used with some drives for
monitoring the cooling fans of the cabinet system. For
details, refer to CIO-01 I/O module for distributed I/O
bus control user's manual (3AXD50000126880
[English]).
Selects the node. Note: All the parameters in this
parameter group concern the selected node only.
Node ID number.
Selects the fan(s) for the operation selected with
parameter 207.03 Command selection.
1 = Fan 1 in the selected node.
1 = Fan 2 in the selected node.
1 = Fan 3 in the selected node.
1 = Fan 4 in the selected node.
Selects the operation for the fan(s) selected with
parameter 207.02 Fan reset selection.
None.
Shows the operating time (in hours) of the fan(s) in
parameters 207.11...207.14.
Resets the on-time counter of the fan(s).
Resets the last identification run of the fan(s).
Resets the on-time counter and identification run data
shown by parameters 207.11...207.14. Can be used if a
fan is replaced with a new one.
Shows the speeds (in Hz) of the fan(s) in parameters
207.11...207.14.
Performs the operation selected with parameter 207.03
Command selection.
Operation done or not requested.
Performs the operation.
Shows the output of the operation selected with
parameter 207.03 Command selection for fan 1.
Fan 1 data.
Shows the output of the operation selected with
parameter 207.03 Command selection for fan 2.
Fan 2 data.
Def / Type
FbEq 16b / 32b
1 / uint16
1 / 1
- / uint16
1 = 1
None / uint16
0
1
2
3
4
5
Done / uint16
0
1
- / real32
1 / 100
- / real32
1 / 100