ABB ACS880 Firmware Manual page 281

No. Name / Range /
Selection
Fieldbus A
Embedded fieldbus
M/F link
Application Program
ATF
DDCS controller
20.2 Ext1 start trigger
type
Edge
Level
20.3 Ext1 in1 source
Not selected
Selected
DI1
DI2
DI3
DI4
Description
The start and stop commands are taken from fieldbus
adapter A.
Note: The start signal is always level-triggered with
this setting regardless of parameter
trigger type.
The start and stop commands are taken from the
embedded fieldbus interface.
Note: The start signal is always level-triggered with
this setting regardless of parameter
trigger type.
The start and stop commands are taken from another
drive through the master/follower link.
Note: The start signal is always level-triggered with
this setting regardless of parameter
trigger type.
The start and stop commands are taken from the
application program control word (parameter
Application control word).
Note: The start signal is always level-triggered with
this setting regardless of parameter
trigger type.
Reserved.
The start and stop commands are taken from an
external (DDCS) controller.
Note: The start signal is always level-triggered with
this setting regardless of parameter
trigger type.
Defines whether the start signal for external control
location EXT1 is edge-triggered or level-triggered.
Note: This parameter is only effective when parameter
20.1 Ext1 commands is set to
Dir, In1 Start fwd; In2 Start
The start signal is edge-triggered.
The start signal is level-triggered.
Selects source 1 for parameter
0 (always off).
1 (always on).
Digital input DI1 (10.2 DI delayed
Digital input DI2 (10.2 DI delayed
Digital input DI3 (10.2 DI delayed
Digital input DI4 (10.2 DI delayed
20.2 Ext1 start
20.2 Ext1 start
20.2 Ext1 start
6.2
20.2 Ext1 start
20.2 Ext1 start
In1 Start, In1 Start; In2
rev, or Control panel.
20.1 Ext1 commands.
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
Parameters 281
Def / Type
FbEq 16b / 32b
12
14
15
21
22
16
Edge / uint16
0
1
DI1 / uint32
0
1
2
3
4
5