ABB ACS880 Firmware Manual page 285

No. Name / Range /
Selection
20.11 Run enable stop
mode
Coast
Ramp
Torque limit
20.12 Run enable 1 source
Not selected
Selected
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
FBA A MCW bit 3
EFB MCW bit 3
DIIL
Description
Selects the way the motor is stopped when the run
enable signal switches off.
The source of the run enable signal is selected by
parameter 20.12 Run enable 1
Stop by switching off the output semiconductors of
the drive.
The motor coasts to a stop.
WARNING!
If a mechanical brake is used, ensure it is safe
to stop the drive by coasting.
Stop along the active deceleration ramp. See parameter
group 23 Speed reference ramp (page
Stop according to torque limits (parameters
30.20).
Selects the source of the external run enable signal. If
the run enable signal is switched off, the drive will not
start. If already running, the drive will stop according
to the setting of parameter
mode.
1 = Run enable signal on.
Note: The warning that indicates a missing signal can
be suppressed using parameter
warning function.
See also parameter 20.19 Enable start
0
1
Digital input DI1 (10.2 DI delayed
Digital input DI2 (10.2 DI delayed
Digital input DI3 (10.2 DI delayed
Digital input DI4 (10.2 DI delayed
Digital input DI5 (10.2 DI delayed
Digital input DI6 (10.2 DI delayed
Digital input/output DIO1
0).
Digital input/output DIO2
1).
Control word bit 3 received through fieldbus interface
A.
Control word bit 3 received through the embedded
fieldbus interface.
DIIL input (10.2 DI delayed
source.
311).
30.19
20.11 Run enable stop
20.30 Enable signals
command.
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.2 DIO delayed status, bit
(11.2 DIO delayed status, bit
status, bit 15).
Parameters 285
Def / Type
FbEq 16b / 32b
Coast (95.20 b10) /
uint16
0
1
and 2
DIIL (95.20 b10);
Selected (95.20 b5);
DI5 (95.20 b9) /
uint32
0
1
2
3
4
5
6
7
10
11
30
32
33