ABB ACS880 Firmware Manual page 289

No. Name / Range /
Selection
DIO2
Other [bit]
20.27 Jogging 2 start
source
20.29 Local start trigger
type
Edge
Level
20.30 Enable signals
warning function
b0 Enable Start
b1 Run enable 1
b2...15 Reserved
0000h...FFFFh
Description
Digital input/output DIO1
0).
See Terms and abbreviations (page
If enabled by parameter
the source for the activation of jogging function 2.
(Jogging function 2 can also be activated through
fieldbus regardless of parameter 20.25.)
1 = Jogging 2 active.
For the selections, see parameter
source.
Note: If both jogging 1 and 2 are activated, the one that
was activated first has priority.
Defines whether the start signal for local control (for
example, control panel or PC tool) is edge-triggered or
level-triggered.
The start signal is edge-triggered.
The start signal is level-triggered.
Selects enable signal (eg. run enable, start enable)
warnings to be suppressed. This parameter can be used
to prevent these warnings from flooding the event log.
Whenever a bit of this parameter is set to 1, the
corresponding warning is suppressed, ie. no warning
is generated even if the signal is switched off.
The bits of this binary number correspond to the
following warnings:
AFEA Enable start signal missing
AFEB Run enable missing
(11.2 DIO delayed status, bit
169).
20.25 Jogging enable, selects
20.26 Jogging 1 start
Parameters 289
Def / Type
FbEq 16b / 32b
11
Not selected / uint32
Edge / uint16
0
1
- / uint16
1 = 1