ABB ACS880 Firmware Manual page 206

206 Parameters
No. Name / Range /
Selection
7.30 Adaptive program
status
b0 Initialized
b1 Editing
b2 Edit done
b3 Running
b4...13 Reserved
b14 State changing
b15 Faulted
0000h...FFFFh
7.40 IEC application Cpu
usage peak
0.0 ... 100.0 %
7.41 IEC application Cpu
load average
0.0 ... 100.0 %
7.51 Slot 1 option module
7.52 Slot 2 option module
0...65535
7.53 Slot 3 option module
0...65535
Description
Shows the status of the adaptive program.
See section Adaptive programming (page
1 = Adaptive program initialized
1 = Adaptive program is being edited
1 = Editing of adaptive program finished
1 = Adaptive program running
Reserved
1 = Error in adaptive program
(Only visible with option +N8010 [application
programmability])
Displays the peak loading of the microprocessor caused
by the application program. This parameter can, for
example, be used to check the effect of a given
application program functionality on the CPU load.
The value is in percent of an internal quota.
Can be reset from the control panel by keeping Reset
depressed for over 3 seconds.
Peak microprocessor loading caused by application
program.
(Only visible with option +N8010 [application
programmability])
Displays the average loading of the microprocessor
caused by the application program. The value is in
percent of an internal quota.
Average microprocessor loading caused by application
program.
Displays the type of module detected in slot 1 of the
drive control unit.
No module detected.
Type of module detected.
Displays the type of module detected in slot 2 of the
drive control unit.
No module detected.
Type of module detected.
Displays the type of module detected in slot 3 of the
drive control unit.
No module detected.
Type of module detected.
Def / Type
FbEq 16b / 32b
- / uint16
69).
1 = 1
- / real32
10 = 1 % / 10 = 1 %
- / real32
10 = 1 % / 10 = 1 %
- / uint16
0
1
- / uint16
1 = 1 / 1 = 1
0
1
- / uint16
1 = 1 / 1 = 1
0
1