ABB ACS880 Firmware Manual page 577

No. Name / Range /
Selection
91.6 Module 2
temperature
0.0 ... 1000.0 °C
91.10 Encoder parameter
refresh
Done
Refresh
91.11 Module 1 type
None
FEN-01
FEN-11
FEN-21
FEN-31
FSE-31
91.12 Module 1 location
1...254
91.13 Module 2 type
None
FEN-01
FEN-11
FEN-21
FEN-31
FSE-31
Description
Displays the temperature measured through the sensor
input of interface module 2. The unit (°C or °F) is
selected by parameter
Note: With a PTC sensor, the unit is ohms.
Note: This parameter is read-only.
Temperature measured through interface module 2.
Validates any changed encoder interface module
parameters. This is needed for any parameter changes
in groups 90...93 to take effect.
After refreshing, the value reverts automatically to
Done.
• Permanent magnet motors only: The drive will
perform a fresh autophasing routine (see page
102) at next start if the motor feedback encoder
settings have been changed.
• The parameter cannot be changed while the drive
is running.
Refreshing done.
Refreshing.
Defines the type of the module used as interface
module 1.
None (communication disabled).
FEN-01.
FEN-11.
FEN-21.
FEN-31.
FSE-31.
Specifies the slot (1...3) on the control unit of the drive
into which the interface module is installed.
Alternatively, specifies the node ID of the slot on an
FEA-03 extension adapter.
Slot 1 = 1; Slot 2 = 2; Slot 3 = 3
4...254: Node ID of the slot on the FEA-03 extension
adapter
Defines the type of the module used as interface
module 2.
None (communication disabled).
FEN-01.
FEN-11.
FEN-21.
FEN-31.
FSE-31.
96.16 Unit selection.
Parameters 577
Def / Type
FbEq 16b / 32b
- / real32
- / -
Done / uint16
0
1
None / uint16
0
1
2
3
4
5
2 / uint16
1 = 1 / 1 = 1
None / uint16
0
1
2
3
4
5