ABB ACS880 Firmware Manual page 394

394 Parameters
No. Name / Range /
Selection
Counted power ups
Counted DC charges
33.50 Value counter 1
actual
-2147483000...2147483000
33.51 Value counter 1 warn
limit
-2147483000...2147483000
33.52 Value counter 1
function
b0 Counter mode
b1 Warning enable
b2...15 Reserved
0000h...FFFFh
33.53 Value counter 1
source
Not selected
Motor speed
Other [bit]
Description
A883 Power ups.
A885 DC charge.
Displays the actual present value of value counter 1.
The value of the source selected by parameter
Value counter 1 source
and added to the counter. A divisor can be applied to
the count (see 33.54 Value counter 1
When the counter exceeds the limit set by
counter 1 warn limit, bit 4 of
to 1.
The warning specified by
message is also given if enabled by
1 function.
The counter can be reset from the Drive Composer PC
tool, or from the control panel by keeping Reset
depressed for over 3 seconds.
Actual present value of value counter 1.
Sets the limit for value counter 1.
With a positive limit, bit 4 of
to 1 (and a warning optionally generated) when the
counter is equal or greater than the limit.
With a negative limit, bit 4 of
to 1 (and a warning optionally generated) when the
counter is equal or smaller than the limit.
0 = Counter disabled.
Limit for value counter 1.
Configures value counter 1.
0 = Loop: When the limit is reached, the counter is reset.
The counter status (bit 4 of 33.1) switches to 1 for one
second. The warning (if enabled) stays active for at
least 10 seconds.
1 = Saturate: When the limit is reached, the counter
status (bit 4 of 33.1) switches to 1, and remains so until
33.50 is reset. The warning (if enabled) also stays active
until 33.50 is reset.
0 = Disable: No warning is given when the limit is
reached
1 = Enable: A warning (see 33.55) is given when the limit
is reached
Selects the signal to be monitored by value counter 1.
None (counter disabled).
1.1 Motor speed used.
See Terms and abbreviations (page
is read at one-second intervals
divider).
33.51 Value
33.1 Counter status
33.55 Value counter 1 warn
33.52 Value counter
33.1 Counter status
33.1 Counter status
169).
Def / Type
FbEq 16b / 32b
14
15
0 / real32
33.53
is set
- / -
- / real32
is set
is set
- / -
- / uint16
1 = 1
Not selected / uint32
0
1