ABB ACS880 Firmware Manual page 496

496 Parameters
No. Name / Range /
Selection
60.23 M/F status
supervision sel 1
b0 Follower 1
b1 Follower 2
b2 Follower 3
b3 Follower 4
b4 Follower 5
b5 Follower 6
b6 Follower 7
b7 Follower 8
b8 Follower 9
b9 Follower 10
b10 Follower 11
b11 Follower 12
b12 Follower 13
b13 Follower 14
b14 Follower 15
b15 Follower 16
0000h...FFFFh
Description
(This parameter is only effective when the drive is the
master on a D2D link. See parameters
communication port and
In the master, parameters
sel 1 and 60.24 M/F status supervision sel 2
followers whose status word is monitored by the
master.
This parameter selects the followers (out of followers
1...16) whose status words are monitored by the
master.
If a follower reports a fault (bit 3 of the status word is
on), the action specified in
is taken. Bits 0 and 1 of the status word (ready states)
are handled as defined by
Using 60.27 M/F status supv mode sel 1
status supv mode sel 2, it is possible to define whether
any given follower is only monitored when it is stopped.
Note: Also activate communication supervision for the
same followers in parameter
supervision sel 1.
The status of communication is shown by
communication status 1
status 2.
Status of follower 1 is monitored.
Status of follower 2 is monitored.
Status of follower 3 is monitored.
Status of follower 4 is monitored.
Status of follower 5 is monitored.
Status of follower 6 is monitored.
Status of follower 7 is monitored.
Status of follower 8 is monitored.
Status of follower 9 is monitored.
Status of follower 10 is monitored.
Status of follower 11 is monitored.
Status of follower 12 is monitored.
Status of follower 13 is monitored.
Status of follower 14 is monitored.
Status of follower 15 is monitored.
Status of follower 16 is monitored.
60.1 M/F
60.3 M/F mode.)
60.23 M/F status supervision
specify the
60.17 Follower fault action
60.18 Follower enable.
and 60.28 M/F
60.19 M/F comm
62.37 M/F
and 62.38 M/F communication
Def / Type
FbEq 16b / 32b
- / uint16
1 = 1