ABB ACS880 Firmware Manual page 398

398 Parameters
No. Name / Range /
Selection
b6 Module found in slot
3
b7 Fault active in slot 3
b8 Warning active in
slot 3
b9...15 Reserved
0000h...FFFFh
35.5 Motor overload level
0.0 ... 300.0 %
35.9 Temperature
Calibration status
word
b0 Temperature 1
calibration done
b1 Temperature 2
calibration done
b2...15 Reserved
0000h...FFFFh
35.11 Temperature 1
source
Disabled
Estimated
temperature
Description
1 = Yes: An FPTC-xx module has been detected in slot
3.
1 = Yes: The module in slot 3 has an active fault
Safe motor temperature
1 = Yes: The module in slot 3 has an active warning
(A499 Motor temperature
Displays the motor overload level as a percent of the
motor overload fault limit. See parameter
overload action and section
protection (page 132).
Motor overload level.
0.0% No motor overloading.
88.0% Motor overloaded to warning level.
100.0% Motor overloaded to fault level.
Shows temperature calibration status word.
Calibration status of temperature 1. See parameter
35.17 Temperature 1 calibration.
Calibration status of temperature 2. See parameter
35.27 Temperature 2 calibration.
Selects the source from which measured temperature
1 is read.
For wiring examples, see the hardware manual of the
drive.
Usually this source is from a sensor connected to the
motor controlled by the drive, but it could be used to
measure and monitor a temperature from other parts
of the process as long as a suitable sensor is used as
per the selection list.
None. Temperature monitoring function 1 is disabled.
Estimated motor temperature (see parameter
Motor estimated temperature).
The temperature is estimated from an internal drive
calculation. It is important to set up the ambient
temperature of the motor in
temperature.
3).
3).
35.56 Motor
Motor overload
35.1
35.50 Motor ambient
Def / Type
FbEq 16b / 32b
(4993
1 = 1
- / real32
10 = 1 % / 10 = 1 %
- / uint16
1 = 1
Disabled / uint16
0
1